Loading ...
Loading ...
Loading ...
Replacing the reversing lamp and inner
brake lamp
1. Loosen the bottom holder, arrow 1.
2. Loosen the top holder, arrow 2. To do so,
press in the middle latch and then press
out both outside latches.
Remove the lamp holder, arrow 3.
3. Unscrew the defective bulb of the revers‐
ing or brake lamp from its socket counter‐
clockwise.
4. Insert the new bulb.
Installing the bulb holder
1.
Insert the two contacts, arrow 1, into the
connections, arrow 2.
2. Press on the bulb holder, arrow 3. Make
sure that the two exterior holders latch into
place.
3. Swing the trim back onto the trunk lid and
secure.
4. Place the hinge trim over the hinge and
push it up until the retaining pin engages.
Close the clips.
5. Install the wire cable on the handle and en‐
gage the handle on the holder.
6. Install the holder for the warning triangle.
7. Apply the warning triangle.
Rear lamp, license plate lamp and
central brake lamp
Follow general instructions, refer to page 207.
These lights are made using LED technology.
Contact your service center in the event of a
malfunction.
Changing wheels
Hints
When using run-flat tires or sealants, a tire
does not need to be changed immediately in
the event of pressure loss due to a flat tire.
Which is why no spare tire is available.
The tools for changing wheels are available as
accessories from your service center.
Jacking points for the vehicle jack
The jacking points for the vehicle jack are lo‐
cated at the positions shown.
Vehicle battery
Maintenance
The battery is maintenance-free.
Seite 213
Replacing components Mobility
213
Online Edition for Part no. 01 40 2 960 520 - II/15
Loading ...
Loading ...
Loading ...