Loading ...
Loading ...
Loading ...
12 49-55114
Starting the dishwasher - Model GSD4000 only
USING THE DISHWASHER
Start
1
The door must be closed and locked into place to select a LOAD SELECTION or an OPTION.
2
If the door is opened during a cycle and left open, the dishwasher will beep once every 30 seconds until the
door is closed and latched into place.
Close and latch the door. Touch the START/RESET pad to begin the cycle. Water fill begins and approximately 60
seconds later the wash action begins.
NOTE: The dishwasher remembers your last cycle so you don’t have to reprogram each time. When the dishwasher
is loaded and the door latch is in the locked position, the control panel lights will be on and display the last settings
you selected.
If you don’t want to change any of the settings, simply touch the START/RESET pad to begin
the cycle.
Also, if a power failure occurs, NORMAL and HEATED DRY will automatically be programmed.
Make any new selections and touch the START/RESET pad to begin the cycle.
Clean
This light is illuminated when a wash cycle is complete. The light will stay ON until the door is opened.
Flashing Display Lights
Lights What It Means What to do
RESET
STARTSTART
This is normal. The START/
RESET pad has been
pressed.
Allow the dishwasher to drain and reset before you start
a new wash cycle.
CLEANCLEAN
Plus a beeping sound
Control Error
Press the START/RESET pad to turn off the beeper. If
the CLEAN light continues to flash, call for service.
Plus a beeping sound
Control Error Press the START/RESET pad to turn off the beeper and
the dishwasher will attempt to reset. Restart the wash
cycle. If this error continues, turn off the power to the
dishwasher at the circuit breaker for 30 seconds. Try
the dishwasher again. If the error is still present, call for
service.
Loading ...
Loading ...
Loading ...