Loading ...
Loading ...
Loading ...
4
Glass Lid Models
• There are two (2) glass lids, a smaller one that ts in the lower track of the freezer and a
larger one that ts in the upper track. The lower track has two (2) round retaining studs
and the upper has four (4) round retaining studs.
• Install the lower glass rst. Again, the lower glass is the smaller of the two. It has a exible
vinyl seal and a lock plate. The exible seal should be facing up and positioned on the end
away from the two round retaining studs. Place the panel in the center and slide along the
lower track until it is secure under the two retaining studs.
• Place the upper glass panel over the lower glass panel already in place. Slide it over the
lower lid past the exible seal. You will notice a slight resistance with the lower lid gasket.
Slide the upper panel under the four studs on the upper track of the frame.
• When properly installed, there is a seal formed by the exible vinyl seal between the two
glass lids.
The following tools are required to assemble and install the casters to the unit:
First Steps
Caster Set-up
A Wrench (1)
B Screws (16)
C Casters (4)
1. With an assistant, tilt the unit until it is resting on its back. Take care to protect the back
from being scratched during this process.
2. Using the wrench provided and the sixteen (16) screws, install all four (4) casters in the
tapped holes in the bottom of the unit. Tighten the screws securely.
3. With an assistant, tilt the unit back up onto its casters.
4. To prevent unintended movement, block casters once the unit is in place.
Appliance Placement
Leave a three (3) inch space on all sides and the back of the cabinet for ease of installation,
proper air circulation and electrical connections. Choose a place that is near a grounded electrical
outlet. For the most efcient operation, the appliance should be located where surrounding
temperatures will not drop below 40ºF (5ºC) or exceed 110ºF (43ºC). Additional compressor
heaters are not recommended.
Insulation
The insulated space of this cabinet is sealed to maintain peak efciency. DO NOT drill holes in the
cabinet. Holes drilled in the cabinet may destroy that seal and damage electrical wiring located
in the insulated space. It may also pierce and damage the sealed refrigeration system in the
insulated space.
DAMAGED ELECTRICAL WIRING OR WET INSULATION CAUSED BY DRILLING WILL
VOID THE WARRANTY.
Loading ...
Loading ...
Loading ...