Loading ...
Loading ...
Loading ...
16. Odometer Display / Electronic Vehicle Information
Center (EVIC) Display Area — If Equipped
Odometer Display
The odometer display shows the total distance the ve-
hicle has been driven. U.S. Federal regulations require
that upon transfer of vehicle ownership, the seller certify
to the purchaser the correct mileage that the vehicle has
been driven. If your odometer needs to be repaired or
serviced, the repair technician should leave the odometer
reading the same as it was before the repair or service. If
s/he cannot do so, then the odometer must be set at zero,
and a sticker must be placed in the door jamb stating
what the mileage was before the repair or service. It is a
good idea for you to make a record of the odometer
reading before the repair/service, so that you can be sure
that it is properly reset, or that the door jamb sticker is
accurate if the odometer must be reset at zero.
The two trip odometers show individual trip mileage. To
switch from odometer to trip odometers, press and
release the TRIP ODOMETER button.
To reset a trip odometer, display the desired trip odom-
eter to be reset then push and hold the button for
approximately two seconds until the display resets.
Vehicle Odometer Messages
When the appropriate conditions exist, the following
messages will display in the odometer:
ECO ...................Fuel Saver Indicator Off
ECO-ON ................Fuel Saver Indicator On
noFUSE .......................... Fuse Fault
LoW tirE .................... TirePressure Low
CHANgE OIL............... OilChange Required
ESCOFF ............ Electronic Stability Control Off
gASCAP ...................... GasCapLoose
HOTOIL ...................Engine Oil Too Hot
LoCOOL................... LowEngine Coolant
4
UNDERSTANDING YOUR INSTRUMENT PANEL 253
Loading ...
Loading ...
Loading ...