Loading ...
Loading ...
Loading ...
15
Removing a Preset Point
Removing Preset Points is performed in much the same manner as defining them.
Once a Preset Point has been removed, selecting it as detailed opposite will no
longer have any effect, until a new point is set.
• Press the DELETE button on the remote, and hold for two seconds.
• The display will now read “Clr-”
• Press a number key to select a Preset Point number. To choose a Preset Point
with a value higher than 10, press the -/-- button first.
• Press ENTER to confirm.
• The selected Preset Point will now no longer be set.
Cruise Mode
Whilst the PRO-750 is in Cruise Mode, the camera will move continuously and
automatically, only pausing when it arrives at Preset Points for a short interval.
There are two ways to enter Cruise mode.
Auto-scan (Cruise) Mode
When in Auto-scan Mode, the PRO-750 will continuously move automatically,
attempting to observe as much of the field of view as practicable in the shortest
time it can.
• To enter Auto-scan Mode, press AUTO.
• For an alternate Auto-scan mode, go to Preset Point 99.
Manual Cruise Mode
You can program lists of Preset Points for the PRO-750 to view in order.
• First, create all the Preset Points you wish to see, as detailed on page 8.
• Press and hold PATTERN for two seconds.
• The display will now read “PStA”.
• Press the NUMBER button for the first Preset Point you want in the programmed
loop, using the -/-- button to access points higher than 10 if necessary.
• Press ENTER once the camera has moved to that Preset Point to confirm.
• Repeat for the other Preset Points you want on the loop, in the order that you
want them to be accessed. Remember to press ENTER each time to confirm
your selection.
• Press and hold PATTERN for two seconds. The display will now show “PSt0”
confirming that the pattern programming has ended and the pattern has been
saved.
• Press RUN to initiate the programmed pattern, and press RUN again to stop
the pattern.
Loading ...
Loading ...
Loading ...