Loading ...
Loading ...
Loading ...
7
1. Connect the 2 black wires (C) together using a UL-listed wire
connector.
2. Connect the 2 white wires (D) and the green (or bare) ground
wire (of the oven cable) using a UL-listed wire connector.
3. Connect the 2 red wires (G) together using a UL-listed wire
connector.
4. Install junction box cover.
Install Oven
1. Using 2 or more people, lift oven partially into cabinet
cutout. Use the oven opening as an area to grip.
NOTE: Push against seal area of oven front frame when
pushing oven into cabinet. Do not push against outside
edges.
2. Push against the seal area of the front frame to push the
oven into the cabinet until the back surface of the front
frame touches the front wall of the cabinet.
3. Push oven completely into cabinet and center oven into
cabinet cutout.
4. Remove the tape from black front trims.
■ Securely fasten the oven to the cabinet using the #8-14
x ¾" screws provided.
■ Insert the screws through holes in black trim aligning with
holes in oven frame. Do not overtighten screws.
A. Oven frame
B. Oven frame hole
C. Black trim piece
5. The bottom vent is shipped in the foam packing at the top
of the oven. Install the bottom vent (C) as follows:
■ Align vent tab (B) with oven frame (A) as shown.
■ Using one #8-18 x ³⁄8" screw (D) on each side of the vent
tab (B), fasten the vent securely to the oven.
6. Replace oven racks.
7. Replace the oven door. See the “Replace Oven Door(s)”
section.
8. Check that door is free to open and close. If it is not,
repeat the removal and installation procedures. See
“Prepare Built-In Microwave/Oven Combination” section.
9. Reconnect power.
10. The display panel will light briey, and “PF” should appear
in the display.
11. If the display panel does not light, please reference
the “Warranty” section of the Use and Care Guide.
A. Oven frame
B. Vent tab
C. Bottom vent
D. #8-18 x ³⁄8" screws
Install Warming Drawer Deflector Kit
(Only for Ovens Installed Above Warming
Drawers)
On combo microwave/oven models installed above a warming
drawer, a warming drawer deector kit must be installed.
See the “Tools and Parts” section for ordering information.
Parts Supplied
A. Phillips head screws (4) only 2 screws
for 27" (68.6 cm) size
B. Warming drawer deector (1)
A
B
C
B
A
A
C
D
B
Loading ...
Loading ...
Loading ...