Loading ...
Loading ...
Loading ...
11
4. The ice maker is equipped with a built-in water
strainer. If your water conditions require a second
water strainer, install it in the 1/4" (6 mm) water line at
either tube connection. Obtain a water strainer from
your nearest appliance dealer.
5. Plug in refrigerator drawers or reconnect power.
MOVE THE REFRIGERATOR DRAWERS TO
FINAL LOCATION
1. Place top of cardboard carton or plywood under the
appliance. Remove dolly.
2. Do not remove film or cover.
3. Plug into a grounded 3 prong outlet.
4. Move the refrigerator drawers straight back and
evenly in front of the opening.
INSTALL CUSTOM OVERLAY PANEL
IMPORTANT:
For standard stainless steel models, skip these
instructions and go to "LEVEL THE REFRIGERATOR
DRAWERS" section.
Create a custom overlay panel according to the
specifications in “Custom Overlay Drawer Panels.”
JennAir is not responsible for the removal or addition
of molding or decorative panels that would not allow
access to the refrigerator drawers for service.
ATTACH THE OVERLAY PANEL
NOTE: If the overlay hooks are not installed, see “Custom
Overlay Drawer Panels” for overlay hook locations. The
location of the hooks must be as precise as possible. If
the custom panel is incorrectly placed, the panel may
interfere with optimal use of the drawers.
1. Attach the custom handle of your preference on the
overlay before attaching the overlay to the drawer of
the refrigerator.
NOTE: Custom handles may vary in dimensions. Holes
must be made on the panel according to the specific
dimensions of your handle.
2. Attach the hooks to their corresponding recessions
on the panel, using the SS Flat M4x12 screws. Two
screws are needed per hook. The hooks must be on
the outer edge of the panel.
3. Gently pull back the gasket from the top corners of
the door until you can see the screw that is behind
the gasket. There is one screw on each side. It is not
necessary to remove the gasket.
4. Remove the screws behind the gasket (one per side).
5. Align the panel to the drawer and position the overlay
panel 1/2" (12.5 mm) higher than the door. Position
the overlay hooks with the pilot holes and push the
hooks into the holes. The drawer has insulant foam
in its interior so you may feel some interference while
pushing. Push until the hooks go through the foam.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
Loading ...
Loading ...
Loading ...