Loading ...
Loading ...
Loading ...
20 electrolux
Installation Instructions
1 Safety instructions
Warning! This must be read!
The laws, ordinances, directives and stand-
ards in force in the country of use are to be
followed (safety regulations, proper recycling
in accordance with the regulations, etc.)
Installation may only be carried out by a qual-
ified electrician.
The minimum distances to other appliances
and units are to be observed.
Anti-shock protection must be provided by
the installation, for example drawers may
only be installed with a protective floor direct-
ly underneath the appliance.
The cut surfaces of the worktop are to be
protected against moisture using a suitable
sealant.
The sealant seals the appliance to the work
top with no gap.
When building in, protect the underside of
the appliance from steam and moisture, e.g.
from a dishwasher or oven.
Avoid installing the appliance next to doors
and under windows. Otherwise hot cook-
ware may be knocked off the rings when
doors and windows are opened.
z
Risk of injury from electrical current.
• The electrical mains terminal is live.
• Make electrical mains terminal free of
voltage.
• Follow connection schematic.
• Observe electrical safety rules.
• Ensure anti-shock protection by install-
ing correctly.
• The appliance must be connected to the
electrical supply by a qualified electri-
cian.
z
Risk of injury from electrical current.
• Loose and inappropriate plug and sock-
et connections can make the terminal
overheat.
• Have the clamping connections correct-
ly installed by a qualified electrician.
• Use strain relief clamp on cable.
• CAUTION: The surface temperature ex-
ceeds 95°C. To avoid a hazard, under-
bench access must be restricted.
• Supply cords must have a temperature
rating not less than 105°C.
• The ventilation gap requirement of 5mm
underneath the cooktop must be ob-
served.
Electrical Connection
Before connecting, check that the nominal
voltage of the appliance, that is the voltage
stated on the rating plate, corresponds to
the available supply voltage. Also check the
power rating of the appliance and ensure
that the wire is suitably sized in accordance
with local wiring rules. The rating plate is lo-
cated on the lower casing of the hob.
The heating element voltage is AC230V~.
The appliance also works perfectly on net-
works with AC220V~ or AC240V~. Means
for disconnection must be incorporated in
the fixed wiring in accordance with local wir-
ing rules.
The hob is to be connected to the mains us-
ing a device that allows the appliance to be
disconnected from the mains at all poles with
a contact opening width of at least 3 mm,
eg. automatic line protecting cut-out,earth
leakage tripsorfuse.
If this appliance’s mains cable is damaged, it
must be replaced by a special cable (type
H05BB-F Tmax 90°C; or higher). The latter is
available from the Customer Care Department.
The connection must be carried out as
shown in the diagram, refer to the sticker on
the back of the hob for wiring connection di-
agram. The connecting links should be fitted
according to the appropriate connection di-
agram. Note for single phase connection,
the link (or bridge) will need to be fitted be-
tween terminals 1 & 2 (refer to the connec-
tion sticker on back of the unit). The earth
lead is connected to terminal E. The earth
lead must be longer than leads carrying elec-
tric current.
The cable connections must be made in
accordance with regulations and the
terminal screws tightened securely.
Finally, the connecting cable is to be secured
with the mains cable cleat and the covering
closed by pressing firmly (lock into place).
Before switching on for the first time, any
protective foil or stickers must be removed
from the glass ceramic surface.
1 Once connected to the mains supply
check that all cooking zones are ready
for use by briefly switching each on in
turn at the maximum setting.
Loading ...
Loading ...
Loading ...