User Manual Frigidaire GLTF2940FS Gallery 3.5 Cu. Ft. Front Load Washer

Yes, you can! Detergent Boosters or enzyme products may be added with your detergent.

If your washer does not start, check the following:

Ensure the washer is levelDon’t forget to press the START button after making your selections.

If the washer is left on for more than 10 minutes without pressing the START button, the washer will automatically turn off and you will need to start over making your selections.

Make sure you have not unintentionally activated the Delay Start option.The wash cycle might be in a pause stage.

This is normal, a pause occurs between the Wash and Spin cycles, with a longer pause occurring during the Soak cycle.The lid may not be completely closed.

For your safety, the washer will not operate when the lid is not closed properly.The power cord may not be plugged in or the connection may be loose. Check that your washer’s plug fits tightly into the wall outlet.

Note: Do not use an extension cord. The power to the washer may be greatly reduced and not allow your washer to perform properly.The water valves must be turned on and water available to the unit.Ensure the water pressure in your house is high enough for the unit to operate properly.

A fuse may be blown in your home, or a circuit breaker tripped. If this is the case, reset the circuit breaker or replace the fuse (but do not increase the fuse capacity).

If you have an overloaded circuit, please contact a qualified electrician.If you are unable to resolve an issue or need more information, please contact us.

Once you have loaded your washer and closed the lid, press the POWER button to turn on your appliance.

Then, turn the cycle selector in either direction to scroll to your desired cycle. In some models the indicator for your selected cycle will be illuminated. Based on the cycle selected, the estimated cycle time, wash temperature, soil level and options associated with the cycle chosen may also illuminate.

After making your selections, press START to begin.

In most models:

To change your cycle, settings or options once the load has started, you will need to press the POWER button before selecting new ones.

Simply turning the cycle selector will not change the selection. If changes are attempted after the cycle starts, the lights will flash and a signal will beep.

TIP: For descriptions of each cycle, setting and option…and when best to use, check out your Owner’s manual for more information.

If your load is out of balance, it may prevent the washer from spinning.

Rearrange the items in your load to allow proper spinning, possibly adding one or two similar items to help balance the load.

A If the load is comprised of items that cannot be distributed around the drum, such as a single pillow or stuffed animal, the washer will not spin.

Additional items will need to be added to the unit to better balance the weight of the load. A If you are unable to resolve an issue or need more information, please contact us.