Loading ...
Loading ...
Loading ...
12 Wait until the machine stops dispensing water. The descaling procedure
is finished when the tick appears on the display.
13 Press the OK button to exit the descaling procedure. The machine starts
heating up and performs the automatic rinsing cycle.
14 Remove and empty the container.
15 Clean the classic milk frother after descaling.
16 Clean the brew group by performing the 'Weekly brew group cleaning'
cycle.
17 Reinstall the Intenza+ water filter.
What to do if the descaling procedure is interrupted
Once the descaling procedure has started, you must complete it till the very
end without switching off the machine. If the machine gets stuck during the
cycle, you can exit the descaling procedure by pressing the standby button.
If this occurs, or in case of a power failure or accidental disconnection of the
cord, do the following:
1 Turn off the machine.
2 Empty and rinse the water tank thoroughly.
3 Fill the water tank up to the CALC CLEAN level indication and turn the
machine back on.
-
The machine will heat up and perform an automatic rinsing cycle.
4 Before brewing any beverages, perform a manual rinsing cycle (see
'Manual rinsing cycle').
Note: If the descaling procedure was not completed, the machine will
require another descaling procedure as soon as possible.
Warning icons and error codes
The warning icons are displayed in red. Below you find a list of the warning
icons that may appear on the display and their meaning.
-
Fill the water tank with fresh water to the MAX level indication.
-
The bean hopper is empty. Put new coffee beans in the bean hopper.
-
The brew group is not in the machine or it is not inserted properly. Insert
the brew group.
23
English
Loading ...
Loading ...
Loading ...