Loading ...
Loading ...
Loading ...
B
3. Clean the door with a wet sponge and rub it
dry with a soft cloth. Do not use steel wool,
acids or abrasive cleaning agents because they
can damage the surface.
When the oven door is clean, install the glass panel
in the opposite sequence. The screen-printing zone
must face the inner side of the door. Make sure that
after the installation the surface of the glass panel
frame on the screen-printing zones is not rough
when you touch it. Make sure that you put the glass
panel in the rubber distance holders.
REPLACING THE LAMP
WARNING! Risk of electric shock.
The lamp can be hot.
1. Turn off the oven.
Wait until the oven is cooled down.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
CAUTION! Always hold the halogen
lamp with a cloth to prevent grease
residue from burning on the lamp.
The back lamp
1. Turn the lamp glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C heat-
resistant lamp.
4. Install the glass cover.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem Possible cause Remedy
The oven does not heat up. The oven is deactivated. Activate the oven.
The oven does not heat up. The clock is not set. Set the clock.
The oven does not heat up. The necessary settings are not
set.
Make sure that the settings are
correct.
The oven does not heat up. The fuse is blown. Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
The lamp does not operate. The lamp is defective. Replace the lamp.
Steam and condensation settle
on the food and in the cavity of
the oven.
You left the dish in the oven for
too long.
Do not leave the dishes in the
oven for longer than 15 - 20
minutes after the cooking
process ends.
The display shows "12.00". There was a power cut. Reset the clock.
21
Loading ...
Loading ...
Loading ...