Loading ...
Loading ...
Loading ...
22
Maintenance
Maintenance in winter
① Clean the ice-production system.
② Turn off the power.
③ Empty the water container. Remove the pump hose.
(The pump hose may be removed after removing the back panel from the ice
maker.)
④ Separate the inlet pipe connected with the water supply valve.
⑤ Turn on the power and set the switch at the “WASH” position to open the water
supply valve and to remove the water from the inlet pipe inside the ice maker.
⑥ In the case of the drain pump model, pour 1/2 gallon of RV anti-freeze mixture
(propylene glycol) into the ice container.
Important Information:
Do not use an anti-freeze product intended
for
automobiles.
⑦ Turn off the ice maker and disconnect the plug from the electric outlet.
When using the ice maker after winter, re-connect the pump hose and other
hoses. Repeat the initial starting steps described on page 16.
Adjusting the ice maker
Three items may be adjusted: the detection temperature of the evaporator, the
delay time of the ice-production cycle, and the water supply time.
To adjust the three items, an inspection kit is required.
If the ice maker is adjusted by the user at his/her discretion, a serious incident may
occur.
Important Information: The three items mentioned above should be adjusted by the
engineer of a service center designated by SUMMIT.
Loading ...
Loading ...
Loading ...