Loading ...
Loading ...
Loading ...
en Rinse aid
18
, Rinse aid
Ri n s e ai d
As soon as the low rinse-aid indicator
H is lit on the control panel or is
requested on the front display * ):,
rinse-aid should be topped up.
The rinse aid is required for stain-free
utensils and clear glasses. Use only
rinse aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH, 26°
Clarke, 3.7 mmol/l) only. If the water
hardness is over 21° dH, rinse-aid must
be used.
* depending on the features of your
dishwasher
Top up the rinse-aid as follows:
1. Open dispenser 92; press lug on
the lid (1) and lift (2).
2. Add rinse-aid up to the max. mark.
3. Close the lid.
Lid “clicks” into position.
4. Remove overflowed rinse aid with a
cloth.
This prevents excessive frothing
during the next rinse cycle.
Setting amount of rinse aid
The amount of rinse aid to be
dispensed can be set from 0 to 6. Set
the amount of rinse aid to be dispensed
to 5 to obtain a very good drying result.
Do not change the amount of rinse aid
unless there are streaks or water stains
on the utensils. Set a lower level to
avoid streaks. Set a higher level to
avoid water stains.
Set the amount of rinse aid as follows:
1. Open the door.
2. Switch on ON/OFF switch (.
3. Press Info button { 8 for 3
seconds until the following text is
indicated on the display window at
the top @:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
4. Keep pressing button > )* until the
rinse aid dispenser is indicated on
the display window at the top @.
5. Make the setting with setting buttons
+ - X.
6. Press and hold the Info button {
8 for 3 seconds.
The chosen setting has now been
stored.
2
1
PD[
Loading ...
Loading ...
Loading ...