Loading ...
Loading ...
Loading ...
INSTALLATION
INSTALLATION OF A FRIGIDAIRE PTAC INTO A FRIGIDAIRE WALL SLEEVE
1. Carefully remove shipping tape from the front panel and vent door. See Fig. 8.
2. Remove shipping screw from the vent door, if present. See Fig. 9.
3. Remove front panel. See Fig. 10.
4. Lift unit level and slide unit into wall sleeve until foam seal rests firmly against front of wall sleeve.
5. Secure with four screws (supplied) through the unit flange holes. See Fig. 11.
6. Reinstall front panel. See Fig. 12.
! CAUTION
UNIT DAMAGE HAZARD
Failure to follow this caution may result in equipment
damage or improper operation.
Failure to remove shipping tape and screw will prevent
fresh air vent door from opening and may result in
damage to vent door cable
!
CAUTION
Fig. 8 – Shipping Tape Location
Shipping
tape
Fig. 9 – Shipping Screw Location
Remove shipping
screw if present
Pull out at the bottom to release it from the tabs
(1). Then lift up (2).
Fig. 10 – Removing Front Panel
Fig. 11 – Securing Unit
Place tabs over top rail (1). Push Inward at
bottom until panel snaps into place (2).
Fig. 12 – Replacing Front Panel
2010 Electrolux Home Products, Inc. All rights reserved.
7
Loading ...
Loading ...
Loading ...