Loading ...
Loading ...
Loading ...
6 HUSKY RETRO REFRIGERATOR
TO OPERATE YOUR HUSKY RETRO REFRIGERATOR
Before switching your Husky Retro Refrigerator on, we recommend you allow
it to stand for 12 hours.
1. Clean the inner compartment.
2. Plug in your Husky Refrigerator.
3. The first time you turn the Refrigerator on, check the thermostat to
ensure it is set to “4” and leave at this position for 20 minutes. After
this time, adjust the temperature control setting as per the guide for
setting the thermostat below.
4. To turn the Refrigerator off, turn the thermostat to the “0” position
and disconnect the plug from the mains supply.
NOTE: If the Refrigerator is unplugged or power lost, you must wait 3 to 5
minutes before restarting. If you attempt to restart the Refrigerator before
this delay, the Refrigerator will not start.
THERMOSTAT SETTINGS
Thermostat “0” position indicates the Refrigerator is turned off although
power is still being supplied. By turning the thermostat dial clockwise, the
Refrigerator will turn on automati cally. The settings 1
(MIN) – 7 (MAX) regulate the interior temperature of
the Refrigerator.
Setting 0 = Off (not operating)
Setting 1 (or MIN) = lowest setting (warmest
internal temperature)
Setting 7 (or MAX) = highest setting (coldest
internal temperature)
Adjust the internal temperature as required according to the amount of
product and the ambient temperature. Guide for the thermostat settings are
as follows:
Winter — Setting 1-2
Spring and Autumn — Setting 2-4
Summer — Setting 4-6
The internal temperature varies in different parts of the Refrigerator. The back
of the Refrigerator is coldest.
Retro Manual Australia 0714.indd 6 22/07/2014 08:28
Loading ...
Loading ...
Loading ...