Loading ...
Loading ...
Loading ...
Always disconnect the kettle from the power
outlet before cleaning.
Never immerse the kettle switch area, cord or
power base in water, or allow moisture to come
into contact with these parts.
Descale Your Kettle Regularly
Mineral deposits in tap water solidify when
the water is heated; lime scale may be white,
coloured, even rusty-looking and is normally
visible but phosphate scale isn’t generally visible
although may cause the water to appear cloudy
when heated. This may cause the interior of the
water gauge to discolour, reduce the effectiveness
of the Quiet Boil technology, cause overheating,
trigger the boil-dry cut-out mechanism or even
reduce the kettle’s life.
Even in soft water areas it is important to descale
your kettle regularly to help maintain its lifecyle.
Note: Failure to descale products regularly can
be deemed as negligent handling and any faults
caused by mineral build up will not be covered by
the Sunbeam 12 Month Guarantee.
To remove this build-up, use Sunbeam Descaling
Tablets (EM0010) or Sunbeam Liquid Descaler
(KE0100) which are available from most retailer
or from Sunbeam Appointed Service Agents
Descale Using Descaling Tablets (EM0100)
1. Fill Kettle to MAXIMUM 1L of tap water
2. Avoid contact with skin, remove one tablet
(20g) from sealed pack.
3. Place tablet into kettle. The tablet will begin to
fizz and dissolve.
4. Activate the Sterilise feature. To activate
sterilise feature press and hold button for 1
second. Leave kettle until it beeps.
5. Empty water solution from kettle.
6. Rinse kettle with clean water.
7. Fill the kettle, bring to boil and discard all the
water.
8. If any deposits remain, wipe with a dry cloth.
Alternatively:
1. Fill the kettle with 1/2 cup of lemon juice and
the remainder with water and allow to stand
overnight.
Allow to stand overnight OR for quicker results,
using the sterilising function run through one
cycle and stand for 4 – 5 hours.
2. Empty the water solution from the kettle.
3. Rinse the kettle with clean water.
4. Fill the kettle, bring to boiling, and discard.
this water.
5. If any deposits remain wipe with a dry cloth.
To clean the stainless exterior
The stainless steel surface may be wiped over with
a damp cloth and polished with a soft dry cloth.
Note: Do not put the mesh filter in the dishwasher
CAUTION: Do not use chemicals, steelwool, or
abrasive cleaners to clean the outside of the
kettle, as these will scratch the stainless steel
surface.
To clean the mesh filter
Press the button on the handle to open the hinged
lid. Grasp the top of the mesh filter and pull
upwards to remove. Wash in warm soapy water
and dry thoroughly before replacing in the kettle.
Care and Cleaning
10
Loading ...
Loading ...
Loading ...