Loading ...
Loading ...
Loading ...
6
INSTALLATION INSTRUCTIONS
Before Using your Refrigerator
• Remove the exterior and interior packing.
• Check to be sure you have an instruction manual included in your refrigerator.
• Before connecting the appliance to the power source, let it stand for approximately 2 hours. This
will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
Installing the Refrigerator
• This appliance is designed to be free-standing only, and should not be recessed or built in.
• When installing the unit, allow 5 inches of space at the back, sides and top of the appliance,
which will allow the proper air circulation to cool the compressor and condenser.
• Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extremely cold ambient temperatures may also affect the unit's performance.
• Avoid locating the unit in moist areas.
• Plug the appliance into an exclusive, properly installed and grounded wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or authorized
service center.
• After plugging the appliance into a wall outlet, allow the appliance to cool down for 2 to 3 hours
before placing food inside.
Anti-Tip Bracket Installation
CAUTION: This appliance requires the installation of an anti-tip bracket.
To reduce the risk of tipping the appliance, it must be secured by properly installing the anti-tip device
packed with the appliance.
• The bracket is designed to be secured to either the floor or to the wall behind the appliance.
• Place the anti-tip bracket on the floor. The bracket must be installed at the left side, 1 1/2” from
the left side of the appliance. The bracket will slide into a cut out slot in the rear grille.
• Mark the locations of the three holes of the anti-tip bracket on the floor or on the wall behind the
appliance.
• Secure the bracket using three No. 10 (3/16”) screws.
• Slide appliance into position, making sure the anti-tip bracket slides over the compressor plate.
NOTE: If the appliance is relocated, the bracket must be removed and installed in the new location.
Loading ...
Loading ...
Loading ...