Loading ...
Loading ...
Loading ...
1.
If the engine is cold, idle the engine for 3
to 5 minutes.
2.
Turn the ignition switch to the OFF
position and wait for 2 to 3 minutes.
3.
Place your scooter on its center stand on
a firm, level surface.
4.
Place a drain pan under the drain bolt
and oil plug.
5.
Remove the oil fill cap/dipstick, drain bolt
and sealing washer to drain the oil.
6.
Remove the oil plug, O-ring, spring and
oil strainer screen and let the remaining
oil drain out.
u Discard the oil at an approved
recycling center.
7.
Clean the oil strainer screen.
8.
Check that the oil strainer screen and
sealing rubber are in good condition.
9.
Replace the O-ring and apply a thin coat
of engine oil to the new O-ring before
installing it.
20181018165411_31GGA7000_enu_BOOK Page 64 Thursday, October 18 2018 16:57:25 JST
Engine Oil u Changing Engine Oil, Cleaning Strainer Screen
Maintenance
61
Continued
Oil fill cap/dipstick
Drain bolt
Sealing washer
Oil plug
O-ring
Oil strainer screen
Spring
Loading ...
Loading ...
Loading ...