Instructions for use - Page 16

GB

The machine vibrates a lot during

the spin cycle.

The machine is noisy.

The machine wont spin properly.

The machine leaks from the

dispenser.

The machine leaks (other than

dispenser).

The machine is locked and an error code

the machine is washing.

The word ‘DEMO ON’ appears in-

termittently in the display window

and the drum slowly turns.

The machine just ‘beeps’ when a

programme or option is selected

(Child Lock Symbol is lit).

There is too much foam.

After completing the programme, or

before starting a programme, the ma-

• The load is in a slight out of balance condition and machine is spinning, but at a lower speed.

• There will always be some motor, pump and drum noise during spin.

• Out of Balance detected when attempting to go into a spin cycle - If this happens the ma-

chine will continue to try to repeat the distribution of the load required before the machine

will go into higher spin speeds - This will increase the programme time accordingly. This is

a safety feature to prevent damage. Out of Balance can be caused by washing a single

heavy item (eg duvet, quilt, etc). - Try the programme again using a different load.

• The dispenser drawer is blocked with detergent and requires cleaning.

• The water pressure is too high and requires turning down - turn down the tap

on the water supply pipe slightly and try again.

back on again If the problem persists contact the Technical Assistance Service.

• The machine requires a service wash. Run a 60 degree wash cycle with deter-

gent and no laundry.

• The door will not open until the door lock indicator light goes out shortly after

the program has finished.

• If there is no power to the machine you need to perform the manual unlocking

procedure (see Precautions & Tips).

• The door seal has drainage holes at the bottom - This is normal.

• The water level is correct if it can be seen at the bottom of the door.

• To exit, switch machine off, then press and hold ‘ON/OFF’ and ‘START/PAUSE’

• Too much detergent was used - less detergent is required in soft water.

• To comply with new energy saving regulations the machine is fitted with an

automatic standby system. Press ‘ON/OFF’ button for 3 seconds to activate

the machine, it can then either be switched off or a new programme selected.

• Your washing machine contains sensors that monitor progress during the wash

cycle (eg: Water Levels, Temperatures, Out of Balance loads, Wash time/progress).

Normally, if your machine successfully completes the cycle, there is unlikely to

be anything wrong!

Remember, you will be charged for a service call for problems caused by incorrect installation, as indicated on pages 2 to 4.

Not emptying contents from pockets may cause pump or drain blockages, or may damage the machine.