Midea MSBS584S 584L Side by Side Fridge

User Manual - Page 6

For MSBS584S. Also, The document are for others Midea models: MSBS584W

PDF File Manual, 16 pages, Read Online | Download pdf file

MSBS584S photo
Loading ...
Loading ...
Loading ...
5
Remove all packaging material and adhesive tape before using your new refrigerator. This
includes the foam base and all adhesive tape holding the refrigerator accessories inside and
outside.
Clean both the inside and outside of the refrigerator with a soft cloth and lukewarm soapy
water.
Keep the refrigerator upright and avoid squeezing or vibration during
transport. Avoid a slanting angle over 45 degrees during handling.
Avoid the door or top cap from being under excessive stress when
moving, otherwise it may become deformed.
Positioning your refrigerator
Place your refrigerator in a well ventilated area away from a heat source and direct sunlight.
Do not install the refrigerator in a damp or wet location as this may cause damage to the
insulation and result in leakage. Condensation may also build up on the outer cabinet
causing rust.
Use the front two adjustable feet to level the refrigerator. Rotate the feet in a clockwise
direction to raise the refrigerator and anti-clockwise to lower. Ensure the refrigerator slightly
tilts backwards so that the drawers and doors self-close to provide a consistent closed seal.
There should be a clearance of at least 300mm from the top of
your refrigerator, and 100mm from either the sides of the
refrigerator (or) the back of the unit. If the refrigerator is to sit
flush with the cabinetry, then a 100mm clearance must be
available at each side to allow the doors to open freely and
enable the removal of bins and shelves.
The minimum clearance recommended at each side is 5mm,
if this is the case the doors must sit proud of the cabinetry by
100mm (not flush). A 5mm side clearance will require 100mm
of airspace at the back of the unit to allow for adequate
ventilation.
100mm
5mm
DOORDOOR
5mm
100mm
100mm
CAUTION
Allow for adequate ventilation around your refrigerator
INSTALLATION
Do not connect your refrigerator to the power supply immediately after it is placed
vertically. You should keep it standing for at least 3 hours before connection to let it
settle.
100mm
Minimum
recommended
airspace around
refrigerator
TRANSPORTING
Loading ...
Loading ...
Loading ...