Loading ...
Loading ...
Loading ...
7
Operating Your Kambrook Kettle
Before First Use
Remove any packaging material and
promotional labels before using your
kettle for the first time.
It is recommended before the first use
to fill the kettle to the maximum level
with cold tap water, bring to the boil
and then discard the water.
The kettle will only operate when
positioned on the power base with
the ON/OFF switch in the ‘ON’
position. The kettle will automatically
switch OFF once the boiling cycle has
been completed.
To Use the Kettle
1. To fill the kettle with water,
remove it from the power base
and open the lid by pressing
the button on the top of the
kettle and lifting the lid upwards.
Fill with the desired amount of
water. Do not operate the kettle
without water. Always fill the
kettle between the minimum and
the maximum marks on the water
window. Too little water will result
in the kettle switching off.
2. Ensure that the lid is closed and
locked firmly into place before
placing the kettle on the power
base.
3. Place the kettle firmly onto the
power base. Plug the power cord
into 230/240V power outlet and
switch ‘ON’.
4. Press the ON/OFF switch to the
‘ON’ position. The power ‘ON’
light will illuminate.
NOTE: Never operate the kettle
dry - too little water will result in
the kettle switching ‘OFF’.
Do not overfill the kettle - filling
above the maximum mark on
the water window may result
in boiling water splashing from
the kettle.
NOTE: This kettle must only
be used with the power base
supplied. Use caution when
pouring water from your kettle
as boiling water will scald. Do
not pour the water too quickly.
NOTE: Do not remove the kettle
from the power base during
operation. Ensure the kettle has
switched to ‘OFF’ position after
the water has boiled before
removing the kettle from the
power base.
5. The kettle will automatically switch
‘OFF’ once the water has boiled.
Lift the kettle from the power base
and pour the water. Take care to
hold the kettle level, especially
when filled to the maximum level.
To re-boil it may be necessary to
wait for a few seconds to allow
the control to reset.
Loading ...
Loading ...
Loading ...