Loading ...
Loading ...
Loading ...
en Installation
18
Sliding out the appliance
Note: Before you remove the appliance, protect the hob
with a piece of polystyrene from the packaging.
1. Use a flat-blade screwdriver to push in the fastening
bolt, and turn it 90° until it locks into place. ¨
2. Push in the fastening bolt gently with your fingers,
and turn it until it comes out of the housing along
with the spring.©
Pull gently on the fastening bolt; before you do this,
take hold of the appliance from beneath with the
other hand. ª
3. Carefully remove the appliance.
4. Screw in the filler strip fully.
5. Push in the fastening bolt and turn it 90°.
Note: The fastening pieces on the left and right of
the appliance must be able to move.
Final fitting stage
1. Slide the appliance up into place. ¨
2. Lock the fastening bolts on the left and right. ©
3. Fit the protective caps on the left and right. ª
4. Establish the electrical connection.
Note: The extractor hood's housing can be concealed
within the upper cabinet. In doing so, you must observe
the following:
■ The intermediate floor must not be placed on the
extractor hood's housing.
■ The front panel must not be secured to the housing.
■ Access must be available in order to change the
filter and for the after-sales service.
$ %
&
PP
[
%
$
&
Loading ...
Loading ...