Loading ...
2 / 4
4
Install the mounting plate and test your latch
torque blade
Note: A D-shaped torque blade is shown, but installation is the same for all models.
A
C D
Place the mounting plate on the door so that the torque
blade inserts through the center hole.
Kwikset & Weiser Only:
To determine which mounting
screws to use, test one of
the thicker screws ๎irst.
If the thicker screw ๎its, continue
installing the thicker screws.
If the thicker screw doesn't ๎it,
install the thinner screws.
Remove the masking tape from the exterior deadbolt, and insert
your key and test the latch for smooth operation.
Remove your key and make sure the bolt is fully extended.
fully
extended
If the latch does not
extend or retract
smoothly, adjust the
mounting screws.
B
Keep parallel to the
edge of the door.
Tighten
screws evenly.
Secure the mounting plate with the mounting screws.
5
Install the interior assembly
D
Secure with two (2) interior assembly screws.
bottom
hole
Remove the interior cover and battery pack.
A
align tabs
Gold adapter:
Keep slot vertical.
Press adapter ๎irmly onto
the interior assembly.
Install the adapter on the interior assembly.
back view
of interior
assembly
B
Silver adapter:
Tab is on bottom.
Black adapter:
Curve is on top.
a
b d
Make sure the
turnpiece is in the
vertical position.
Remove the
interior cover.
Remove the battery pack.
Do not
install
batteries
yet.
vertical
c
Make sure shaft is oriented
as shown. If needed, rotate
the shaft to this position.
Stripe should
be vertical.
C
Align the adapter with the torque blade and push the interior assembly
onto the mounting plate.
Schlage Deadbolts Only:
You may need to rotate
the adapter to align with
the torque blade.
actual
size
Loading ...
Loading ...