Loading ...
Loading ...
Loading ...
EN-9
If the door of machine does not close properly, check if the machine is stable on
the floor; if not, adjust the feet and ensure its stable position.
Water connection
İndoor plumbing must be suitable for installing a dishwasher. Also, we recommend
that you fit a filter at the entrance of your place or apartment so as to avoid
any damage to your machine because of any contamination (sand, clay, rust
etc.) that might be occasionally carried in through the mains water supply or the
indoor plumbing, and to prevent such complaints as yellowing and formation of
deposits after washing.
Water inlet hose
Do not use the water inlet hose of your old machine.
Use the new one supplied with your machine instead. If
you will connect a new or long - unused water inlet hose
to your machine ,run water through it for a while before
making the connection. Connect the water inlet hose
directly to the water inlet tap. The pressure supplied by
the tap should be at a minimum of 0.03 Mpa and and at
a maximum of 1 Mpa.If the water pressure is above 1
Mpa,a pressure-relief valve should be fitted inbetween.
After making connections, the tap should be turned on fully and checked for
water tightness.For the safety of machine, turn off the water inlet tap after
finishing each wash programme.
NOTE: Aquastop water etc. spout is used in some
models. In case of using Aquastop, a dangerous
tension exists.Do not cut the Aquastop water spout.
Do not let it get folded or twisted.
Water outlet hose
The water drain hose can be connected either directly
to the water drain hole or to the sink outlet spigot.
Using a special bent pipe (if available), the water can
be drained directly into the sink via hooking the bent
pipe over the edge of the sink. This connection should
be between 50 and 110 cm from the floor plane.
CHAPTER -3: INSTALLING THE MACHINE
Loading ...
Loading ...
Loading ...