Loading ...
Loading ...
Loading ...
Programming HomeLink姞 to a Genie Intellicode姞 2 garage door
opener
Note: The Genie Intellicode 2威 transmitter must already be programmed
to operate with the garage door opener.
Programing the transmitters
To program HomeLink威 to the transmitter you must first put the
transmitter into programming mode. To do this
A. Red LED
B. Green LED
1. Press and hold one of the buttons on the transmitter for 10 seconds.
The LED light will change from green to green and red.
2. Press the same button twice to confirm the change to Programming
mode. If done properly the LED light will appear red.
3. Hold the transmitter within 1–3 inches (2–8 cm) of the HomeLink威
button.
4. Press and hold the both the programmed Genie button and the
HomeLink威 button you want to program. The HomeLink威 LED will flash
rapidly when the programming is successful.
Note: the Genie transmitter will transmit for up to 30 seconds. If
HomeLink威 does not program within 30 seconds the Genie transmitter
will need to be pressed again. If the Genie transmitter LED displays
green and red, release the button until the LED turns off before pressing
the button again.
Once HomeLink威 has been programmed successfully, the Genie
transmitter must be changed out of program mode. To do this:
1. Press and hold the previously programmed Genie button for
10 seconds. The LED will change from red to red and green.
2. Press the same button twice to confirm the change. If done correctly
the LED will turn green.
BA
166 Universal Garage Door Opener
2013 MKT (mkt)
Owners Guide gf, 1st Printing
USA (fus)
Loading ...
Loading ...
Loading ...