Loading ...
Loading ...
Loading ...
3. Options
The light above the selected pad will be ON to indicate which OPTION has been selected.
POWER For use with heavily soiled and/or dried-on, baked-on soils. This option
PRESOAK MUST be selected PRIOR to starting the cycle. This option adds
16 minutes to the cycle time.
HI TEMP RINSE Turns on the heater in all prerinse and final rinse cycles to help prevent
spotting on dishware. This option may be turned ON or OFF during the
wash cycle.
HEATED DRY Shuts off the drying heat options. Dishes air dry naturally and energy is
OFF saved. You can prop the door open after the light goes ON next to the
word CLEAN which appears in the STATUS display for faster drying.
HEATED DRY Turns the heater on for fast drying. This cycle will extend the time
ON to your wash cycle by 30 minutes. NOTE: Cannot be selected with
RINSE & HOLD cycle.
LOCK
When the LOCK pad is touched twice within 3 seconds, all pads become
inoperative. You can lock the controls to prevent any selections from being made.
Or you can lock the controls after you have
started a cycle or selected DELAY
START so the cycle or DELAY START is not interrupted.
Children cannot accidentally start dishwasher by touching pads with this
option selected.
To unlock the dishwasher after it has been locked, touch the
LOCK
pad twice
within 3 seconds. The light above the
LOCK
pad will be off.
DELAY START You can delay the start of a wash cycle for up to 8 hours. Press and hold
the DELAY START pad to choose the number of hours you want to delay
the start of the cycle. The machine will count down and start automatically
at the correct time. NOTE: If you forget to lock the door a reminder signal
will beep until you do so.
RESET To change a cycle after washing starts, touch the START/RESET pad to
cancel the cycle. After water is pumped out and motor stops, you can
reprogram and restart the dishwasher.
4. Start
Close the door until it locks into place and touch the START/RESET pad to begin the cycle.
There is a time delay between start-up and water fill so you will not hear any wash action right away.
The cycle is complete when the light is ON next to the word CLEAN in the STATUS display.
NOTE: The dishwasher remembers your last cycle so you don’t have to reprogram each time.
When the dishwasher is loaded and door latch is in the locked position, the control panel lights
will be on and display the last settings you selected.
If you don’t want to change any of the settings, simply touch the START/RESET pad to begin the
cycle.
Also, if a power failure occurs, NORMAL and HEATED DRY will automatically be programmed.
Make any new selections and touch the START/RESET pad to begin the cycle.
7
Loading ...
Loading ...
Loading ...