Loading ...
Loading ...
Loading ...
5
Parts Supplied
Check that all parts are included.
■ Burner grates
■ Burner caps
■ Griddle drip tray (on griddle models)
Parts Needed
■ All models must be installed with a backguard if installing
at zero clearance to a combustible back wall surface such
as drywall. See “Cabinet Dimensions” in the “Location
Requirements” section for installation requirements.
Check local codes and consult gas supplier. Check existing gas
supply and electrical supply. See the “Electrical Requirements”
and “Gas Supply Requirements” sections.
It is recommended that all electrical connections be made by
alicensed, qualied electrical installer.
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
Donot obstruct ow of combustion and ventilation air.
■ It is the installer’s responsibility to comply with installation
clearances specied on the model/serial/rating plate. The
model/serial/rating plate is located under the console on
theright‑hand side.
■ It is recommended that a 585 CFM (993.9 m
3
/hr) or larger
range hood beinstalled above the cooktop.
■ Follow the range hood or microwave hood combination
installation instructions for dimensional clearances above the
cooktop surface.
■ Recessed installations must provide complete enclosure
ofthe sides and rear of the cooktop.
■ All openings in the wall or oor where cooktop is to be
installed must be sealed.
■ Do not seal the cooktop to the side cabinets.
■ Cabinet opening dimensions that are shown must be used.
Given dimensions are minimum clearances.
■ Grounded electrical supply is required. See the “Electrical
Requirements” section.
■ Proper gas supply connection must be available. See the
“Gas Supply Requirements” section.
IMPORTANT: To avoid damage to your cabinets, check with
your builder or cabinet supplier to make sure that the materials
used will not discolor, delaminate, or sustain other damage. This
oven has been designed in accordance with the requirements
of UL and CSA International and complies with the maximum
allowable wood cabinet temperatures of 194°F (90°C).
Mobile Home - Additional Installation Requirements
The installation of this cooktop must conform to the
Manufactured Home Construction and Safety Standard,
Title24CFR, Part 3280 (formerly the Federal Standard for
Mobile Home Construction and Safety, Title 24, HUD Part
280).When such standard is not applicable, use the Standard
forManufactured Home Installations, ANSI A225.1/NFPA 501A
or local codes.
In Canada, the installation of this cooktop must conform with
thecurrent standards CAN/CSA‑A240‑latest edition or with
localcodes.
Product Dimensions
NOTE: Cooktop features may differ.
30" (76.2 cm) models
Side View of Cooktop
A
D
B
C
E
F
G
A. 29
3
/
8
" (74.6 cm)
B. 1
1
/
4
" (3.2 cm)
C. Island trim or optional
backguard
D. 7
7
/
16
" (18.8 cm)
E. Gas inlet is located 1
7
/
8
"
(4.8cm) from the back of the
cooktop burner base and 4
7
/
8
"
(12.4 cm) in from left-hand side
of the cooktop burner base.
F. 22" (55.9 cm)
G. 3
5
/
8
" (9.2 cm)
A. 27
7
/
8
" (70.8 cm)
B. 29
3
/
4
" (75.6 cm)
C. 3 prong grounding-type power
supply cord
D. Model/serial/rating plate
(located on the underside of
the cooktop burner base)
A
C
B
D
Loading ...
Loading ...
Loading ...