Loading ...
Loading ...
Loading ...
EN
6
6
INSTALLATION
Drilling the Support surface and Fitting the Hood
• The Hood can be fitted directly on the
lower surface of the Wall Units (650
mm min. above the Cooker Top) using
the snap-on Side Supports.
• Make an opening on the lower surface
of the Wall Unit, as indicated. (fig.1)
• Before carrying out the installation,
the wooden transportation protections
screwed on the visor and on the can-
opy body must be removed. (fig.2)
• Choose the correct flange measure
basing on the air outlet diameter and
insert it to the upper air outlet opening.
(fig.3)
• Screw the closing profile 20 onto the
rear part of the hood, using the screws
12f (2.9 x 9.5) provided. (fig.4)
• Open the sliding suction panel.
• Remove the metal grease filters one by
one after having disconnected the rela-
tive fastening elements.
• Close the sliding suction panel again.
• Insert the Hood until the snap-on side
supports click into place. (fig.5)
• Open the sliding suction panel.
• Lock in position by tightening the
screws Vf from underneath the Hood.
(fig.5)
• If necessary, adjust the whole filter
holder unit and proceed as follows:
• Loosen the four adjustment screws
Vr and close the sliding panel
again. (fig.6)
• Move the entire filter holder unit
until it is properly aligned with the
wall unit. (fig.7)
• Keeping the hood canopy still, re-
move the sliding panel and lock the
adjustment screws again. (fig.6)
• The hood can now be fastened to
the wall unit using the four screws
12a (3.5 x 16) provided. (fig.8)
• Replace the metal grease filters.
• Close the sliding suction panel again.
523
162
1
2
5
Vr
6
7
12a
8
4
9
10a
10a
10b
ø
120
3
Loading ...
Loading ...
Loading ...