Loading ...
Loading ...
Loading ...
10
Dishwasher Features
Your Whirlpool dishwasher may have some or all of these features.
Removable Top Rack
The removable top rack allows you to wash larger items such as pots, roasters, and cookie sheets in the bottom rack.
IMPORTANT: Remove dishes prior to removing the top rack from dishwasher.
To remove the rack
1. To gain access to the track stops,
pull the upper rack forward about
halfway out of the tub.
2. Press on the edge of the ridged area
on the track stop while tipping the
track stop toward the center of the
dishwasher. This action releases a
small retaining tab that locks the
track stop to the track. (See “Track
stop - Left.”)
NOTE: It is helpful to use two hands. Take special note of the
orientation of the track stops
3. With the retaining tab released, pull the track stop straight
toward the opposite track to remove it.
4. After removing both track stops, carefully pull the top rack out
of the tracks by rolling it toward you.
5. Replace the track stops by coming up from under the track
and slipping the track stop into the lower slot of the track (See
“Track stop - Right.”) and rotate the track stop into place. Then
press on the edge of the ridged area while pushing the track
stop straight toward the track. This action locks the retaining
tab back into place.
6. Test the track stop by pulling it toward the opposite track to
ensure that it is locked in place.
To replace the rack
1. Gently pull the tracks forward in
dishwasher until they stop.
Remove track stops. (See steps
1-3 above.)
2. Place the back wheels on each
side of the rack into the track
and roll the rack into the tracks,
but do not push the rack all the
way into the tub.
3. Insert front rack wheels on each
side of the rack into the track.
4. Slide the rack into the
dishwasher.
5. Replace the track stops by coming up from under the track
and slipping the track stop into the lower slot of the track (See
“Track stop - Right.”) and rotate the track stop into place. Then
press on the edge of the ridged area while pushing the track
stop straight toward the track. This action locks the retaining
tab back into place.
6. Test the track stop by pulling it toward the opposite track to
ensure that it is locked in place.
IMPORTANT: Be sure that the track stops are locked in place
and cannot be easily removed. They keep the rack from coming
out of the track.
CONTROLS AND CYCLE STATUS
CONTROL PURPOSE COMMENTS
Press to start or resume a wash cycle.
If the door is opened during a cycle or the power is interrupted, the Start/Resume button LED flashes. Cycle will
not resume until door is closed and Start/Resume is pressed.
Press to cancel wash cycle.
Close the door firmly. Press and hold START/RESUME or 3 seconds. The dishwasher starts a 2-minute drain
(if needed). Let dishwasher drain completely.
To follow progress of
your dishwasher cycle.
NOTE: Indicators shown
are not available on
all models.
The Clean indicator glows when a cycle is finished.
If you select the Sani Rinse option, when the cycle is finished, the “Sanitized” indicator
glows. If your dishwasher did not properly sanitize your dishes, the light flashes at the
end of the cycle. This can happen if the cycle is interrupted, or water could not be
heated to required temperature. The light goes off when you open and close door or
when you cancel the cycle.
Track stop - Left
Track stop - Right
Loading ...
Loading ...
Loading ...