Loading ...
Loading ...
Loading ...
TROUBLESHOOTING 13
Troubleshooting
If there is no sound from • Check that receiver/amplifier is on and a source is playing.
any of the speakers: • Check that the powered subwoofer is plugged in, its Power switch
is switched on to
the “ON•” position.
• Check all wires and connections between receiver/amplifier and speakers. Make sure all wires
are connected. Make sure none of the speaker wires are frayed, cut or punctured.
• Review proper operation of your receiver/amplifier.
If there is no sound coming • Check the “Balance” control on your receiver/amplifier.
from one speaker: • Check all wires and con nections between receiver/ amplifier and speakers. Make sure all wires are
connected. Make sure none of the speaker wires are frayed, cut or punctured.
• In Dolby Digital or DTS
®
modes, make sure that the receiver/processor is configured so that the
speaker in question is enabled.
If the system plays at low volumes • Check all wires and con nec ti ons between receiver/amplifier and speakers.
but shuts off as volume is Make sure all wires are connected.
increased: Make sure none of the speaker wires are frayed, cut or punctured.
• If more than one pair of main speakers is being used, check the minimum impedance
requirements of your receiver/amplifier.
If there is low (or no) bass • Make sure the connections to the left and right “Speaker Inputs” have the correct polarity (+ and –).
output: • Make sure the subwoofer is plugged into an active electrical outlet.
• Make sure the powered subwoofer is plugged in and switched on.
• In Dolby Digital or DTS
®
modes, make sure your receiver/processor is
configured so that the subwoofer and LFE output are enabled.
0127CSK - HK TS2_ENG.qxp:29515_HKTS2_English 18/03/09 16:07 Side 13
Loading ...
Loading ...
Loading ...