Loading ...
Loading ...
Loading ...
REAR SPRING
The rear shock absorber spring is adjusted by rotating the adjuster either
clockwise or counter-clockwise to increase or decrease spring tension.
Accessory springs are available through your POLARIS dealer.
HANDLEBARS
The handlebars can be adjusted for rider preference.
WARNING
Improper adjustment of the handlebars or incorrect torquing of the adjuster
block tightening bolts can cause limited steering or loosening of the
handlebars, resulting in loss of control and serious injury or death. Follow the
adjustment procedures exactly, or see your POLARIS dealer for service.
1. Remove the upper headlight pod.
2. Loosen the four handlebar bolts.
3. Adjust the handlebar to the desired height. Be sure the handlebars do not
contact the gas tank or any other part of the machine when turned fully to the
left or right.
4. Torque the front two bolts to 10-12 ft-lbs (14-17 Nm), then torque the rear two
bolts. A gap of up to 1/8" (3 mm) will remain at the rear of the clamp blocks.
CLEANING AND STORAGE
WASHING THE VEHICLE
If a high pressure water system is used for cleaning (not recommended),
exercise extreme caution. The water may damage components and could
remove paint and decals. Avoid directing the water stream at the following items:
• Wheel bearings
• Radiator
• Transmission seals
• Cab and body panels
• Electrical components
• Switches and controls
• Fuel system components
• Labels and decals
If an informational or graphic label becomes illegible or comes off, contact your
POLARIS dealer to purchase a replacement. Replacement safety labels are
provided by POLARIS at no charge.
116
MAINTENANCE
Loading ...
Loading ...
Loading ...