Loading ...
Loading ...
Loading ...
18 49-1000107 Rev. 0
REFRIGERATOR LOCATION
■ Do not install the refrigerator where the
temperature will go below 60°F (16°C) because
it will not run often enough to maintain proper
temperatures.
■ Do not install the refrigerator where the
temperature will go above 100°F (37°C) because it
will not perform properly.
■ Do not install the refrigerator in a location exposed
to water (rain, etc.) or direct sunlight.
■ Install it on a floor strong enough to support it fully
loaded.
CLEARANCES
Allow the following clearances for ease of installation,
proper air circulation and plumbing and electrical
connections.
Sides 1/8”(3mm)
Top 1”(25mm)Cabinet/HingeCover
Back 2”(50mm)
Installation Instructions
INSTALLING THE REFRIGERATOR
IMPORTANT NOTES
This refrigerator without the handles ranges from
33-7/8”to35-1/4”(86cm-89cm)dependingonyour
model (see dimension E on the previous page). Doors
and passageways leading to the installation location
mustbeatleast36”(91.4cm)inordertoleavethe
doors attached to the refrigerator while transporting
it into the installation location. If passageways are
less than 36” (91.4 cm), the refrigerator doors can
easily be scratched and damaged. The doors can be
removed to allow the refrigerator to be safely moved
indoors.
• If you need to remove the door, see Removing
French Doors.
• To remove the freezer door, see Removing
Freezer Drawer.
• If it is NOT necessary to remove doors, leave tape
and all packaging on doors until the refrigerator
is in the final location. Once in place, install door
handles (see Steps 1 and 2).
• SKID REMOVAL: Tilt refrigerator to each side to
remove skid.
• NOTE: Use a padded hand truck to move this
refrigerator. Place the refrigerator on the hand
truck with a side against the truck. We strongly
recommend that TWO PEOPLE move and
complete this installation.
ATTACH FRESH FOOD
HANDLES
Attach the handle to the mounting fasteners
by aligning the slots on the handle with the
mounting fasteners. Slide the handle down until
youheara“click”.
Follow the same procedure for both doors.
1
ATTACH FREEZER HANDLE
Attach the handle to the mounting fasteners by
aligning the slots on the handle with the mounting
fasteners. Slide the handle to the right until you
heara“click”.
2
Mounting
Fasteners
Mounting
Fasteners
INSTALLATION INSTRUCTIONS
Loading ...
Loading ...
Loading ...