Loading ...
Loading ...
Loading ...
8
2. Gently pull down to remove the door from the right top hinge and place it on a padded surface to
avoid the risk of damage. Then remove the right top hinge (4). (Fig. 3)
3. Unscrew and transfer the hinge pin (3) of the hinge plate to the opposite side. (Fig. 2)
4. Pop out the cover caps on the left side of cabinet and use them to cover the screw holes on the right
hand side.
5. Screw the alternative left top hinge (6), included in the fittings, on the left hand side of cabinet. (Fig. 3)
6. Unscrew and transfer the hole cover (7) and lock catch (8) to the opposite side of glass door. (Fig. 4)
7. Rotate the door 180° and relocate it to the designated position. Then screw the bottom hinge
assembly on the left designated position and tighten it after the door is leveled.
ADJUSTING THE HEIGHT OF THE UNIT
The height of the AL57G can be increased by up to 3” by turning the adjustable legs. Once the desired
height has been achieved, the gap between the kick-plate and the floor can be covered by inserting a
kick-plate extender, which is described in the next section.
ADJUSTING THE KICK-PLATE
This appliance includes an adjustable kick-plate extender that is not
required to operate the unit. In order to adjust the kick-plate height,
follow the instructions below:
1. Remove the screws
○
2 from both the bottom left- and bottom
right-hand sides of the kick-plate installed on the unit.
2. Loose or remove the screws
○
1 from both the top left- and top
right-hand sides of the kick-plate installed on the unit.
3. Carefully insert the kick-plate extender under the kick-plate until
the desired height is achieved.
4. Reinsert screws and tighten them.
INSTALLING THE STAINLESS STEEL HANDLE
This appliance includes a stainless steel handle that is not required
to operate the unit. To install the handle, follow the instructions
below:
1. Remove the door gasket
○
2 on the side you wish to install the
handle – you can see two designated holes for handle
installation.
2. Install the handle
○
4 tightly as shown here with two screws
○
1
and flat washers
○
3 provided.
3. Replace the door gasket.
Loading ...
Loading ...
Loading ...