Loading ...
Loading ...
Loading ...
Installation
WARNING!
Refer to Safety chapters.
Before the installation
Before you install the hob, write down the
information bellow from the rating plate. The
rating plate is on the bottom of the hob.
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you assemble
the hob into correct built-in units and work
surfaces that align to the standards.
Connection cable
• The hob is supplied with a connection cable.
• To replace the damaged mains cable use
the following (or higher) mains cable type:
H05BB-F Tmax 90°C. Speak to your local
Service Centre.
Attaching the seal
1. Clean the worktop around the cut out area.
2. Attach the supplied seal stripe to the lower
edge of the hob along the outer edge of the
glass ceramic. Do not extend it. Make sure
that the ends of the seal stripe are located
in the middle of one side of the hob.
3. Add some mm when you cut the seal stripe
to the length.
4. Push the two ends of seal stripe together.
Assembly
min.
50mm
min.
500mm
min.
2mm
12 www.zanussi.com
Loading ...
Loading ...
Loading ...