Loading ...
Loading ...
Loading ...
23
Problem Cause Action
Dishes are not getting dry enough Rinse agent dispenser is empty. (Rinse
1.
agent indicator is activated).
Improper loading of dishes.
2.
Selected cycle does not include drying.3.
Note: Plastic or Teon do not typically dry
as completely as other items due to their
inherent properties.
Add rinse agent. The use of rinse agent im-
1.
proves drying.
Rearrange load to ensure items are not
2.
nested. Refer also to the “Preparing and Load-
ing” section of this manual.
Rinse and Hold setting does not include dry-
3.
ing cycle,
Note: Select models offer an extra heating op-
tions to improve drying performance. Refer to
“Additional Features” under the Dishwasher
Features and Options section of this manual.
Odor Food debris is present at the bottom of
1.
the dishwasher.
Food particles are present near the
2.
door seal.
Dishes left too long in unit before run-
3.
ning a cycle.
Residual water is present at the bot-
4.
tom of the dishwasher.
Drain hose is obstructed.
5.
Remove the lters and clean according to the 1.
“Check/Clean the Filter System” section of this
manual.
Refer to “Clean the Door Gasket and Door
2.
Seal” in the Care and Maintenance section of
this manual .
Run a Rinse/Hold cycle if you do not intend to
3.
immediately wash the dishes.
Ensure the unit has completely drained from
4.
the last cycle. Refer to the “Canceling or
changing the cycle” section of this manual.
Remove any obstructions from the drain hose
5.
by calling qualied personnel.
Note: If odor still persists, run the Normal/Regular
cycle until it ushes and interrupt the cycle and
place an 8 oz. cup of distilled white vinegar solu-
tion on the top rack and then nish the cycle.
Dishwasher not lling with water Restriction in the water supply system.
1.
Previous wash cycle was not com-2.
pleted.
Delay-start is active.
3.
Ensure that the water supply valve (typically 1.
located under kitchen sink) is open and check
that the water supply line has no kinks and
clogs.
Refer to the “Canceling or changing the cycle”
2.
section of this manual.
Cancel the delay-start or wait until delay-
3.
start time completes (times out). Refer to the
“Delay Start” section of this manual.
Water Leaks Suds
1.
Door seal could be pulled away from 2.
track.
Condensation vent is blocked.
3.
Improper installation.4.
Wrong type of detergent results in suds and 1.
leaks. Use only dishwasher detergents. If
suds still persist, then add one tablespoon of
vegetable oil at the bottom of the dishwasher
and run the desired cycle.
Ensure that door seal is in the track.
2.
Ensure that condensation vent is not blocked. 3.
Refer to “Loading Extra Tall Items” in the Pre-
paring and Loading the Dishwasher section
of this manual.
Have proper installation veried by qualied
4.
personnel (water supply, drain system, level-
ing, plumbing).
Tub stains Stains on the dishwasher interior are
1.
due to hardness of water.
Silverware in contact with tub.
2.
Concentrated Lemon juice can reduce the 1.
build up of hard water stains. Run a normal
cycle until it ushes and interrupt the cycle
and then place an 8 oz. cup of the concen-
trated lemon solution on the top rack and
nish the cycle. This can be done periodically
to avoid build up.
Ensure that the silverware does not make
2.
contact with the tub while running a cycle.
Loading ...
Loading ...
Loading ...