Loading ...
Loading ...
Loading ...
EN
5
To disable Wi-Fi module on DEEBOT, turn the robot's Bottom Power Switch ON. Place the robot
on the Charging Dock making sure the Charging Contacts on DEEBOT and the Charging Dock
Pins make a connection. Press and hold the AUTO Mode Button on the robot for 10 seconds until
DEEBOT emits 3 beeps.
To enable Wi-Fi module on DEEBOT, turn the robot's Bottom Power Switch OFF and then power
ON. The Wi-Fi module is turned on when DEEBOT is restarted.
This device complies with Part 15 of the FCC Rules / Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Changes or modications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
— Consult the dealer or an experienced radio/TV technician for help.
To satisfy FCC / IC RF exposure requirements, a separation distance of 20 cm or more should be
maintained between the antenna of this device and persons during device operation.
To ensure compliance, operations at closer than this distance is not recommended.
1. Important Safety Instructions
38. Have servicing performed by a qualified repair person using only
identical replacement parts. This will ensure that the safety of the
product is maintained.
39. Do not modify or attempt to repair the appliance or the battery pack (as
applicable) except as indicated in the instructions for use and care.
40. Place the cords from other appliances out of the area to be cleaned.
41. Do not operate the vacuum in a room that has lit candles on furniture
that the vacuum may accidentally hit or bump into.
42. Do not allow children to sit on the vacuum.
43. Recharge only with the charger specified by the manufacturer. A
charger that is suitable for one type of battery pack may create a risk
of re when used with another battery pack.
44. Use appliances only with specically designated battery packs. Use
of any other battery packs may create a risk of injury and re.
45. Do not handle plug or appliance with wet hands.
Loading ...
Loading ...
Loading ...