Loading ...
Loading ...
Loading ...
GAS COOKTOP INSTALLATION INSTRUCTIONS
(For 30" & 36" Models)
6
4. Once the cooktop is installed, clamp the unit down
as shown (Fig. 6).
To clamp down, insert an angle bracket into the slot
on each side of the unit as shown. Run thumb screw
up through the bracket, up against the bottom of the
counter. Tighten until the unit draws down and is
secure.
1. Wall Outlet Location
Figure 5
2. Cooktop Installation
1. Visually inspect the cooktop for damage.
2. Set the cooktop into the countertop cutout.
After inserting the cooktop into the countertop
opening, make sure the unit is sitting on the
metal ange around the top of the burner
box. Cooktop must not sit on the glass or the
porcelain top. Avoid cutting an oversized hole in
the countertop.
NOTE: Do not use caulking compound; cooktop
should be removable for service when needed.
3. Insert the thumb screw supplied (2) in the angle
bracket as shown below (Fig. 6A).
Figure 6
Countertop
Cooktop (Glass
or Porcelain)
Angle Bracket
Seal (Porcelain
Cooktop Only)
Thumb Screw
3. Provide an Adequate Gas Supply
This cooktop is designed to operate on natural gas at
5" of manifold pressure only.
A pressure regulator is connected in series with the
manifold on the cooktop and must remain in series with
the supply line.
For proper operation, the maximum inlet pressure
to the regulator must be no more than 14" of water
column (W.C.) pressure.
For checking the regulator, the inlet pressure must
be at least 1" (or 2.5 kPa) greater than the regulator
manifold pressure setting. The regulator is set for 5" of
manifold pressure, the inlet pressure must be at least
6".
The gas supply line to the range should be 1/2" or 3/4"
pipe.
4. LP/Propane Gas Conversion
This appliance can be used with Natural gas or LP/
Propane gas. It is shipped from the factory for use with
natural gas.
A kit for converting to LP gas is supplied with your
cooktop. The kit is marked "FOR LP/PROPANE GAS
CONVERSION".
Figure 6A
Angle
Bracket
Thumb
Screw
¾" to 1"
(1,9 to 2,5 cm)
Loading ...
Loading ...
Loading ...