Loading ...
Loading ...
Loading ...
Installation instructions
33 7/8* - 36
22
27 1/2 - 31 1/2**
5 1/8 - 7 3/8
2
1 1/8 - 3 3/4
48 3/4
29 1/8
23 1/2***
['']
Nominal dimensions. Actual measurements may vary.
**Door length.
***Fit the trim kit if the widths of 24'' is required.
*Remove lock nuts for an installed height of 33 7/8''.
It is important that you read through and follow the instructions and
directions below. Conduct installation and connection in accordance
with the separate installation instructions.
Important safety instructions
• Connections to electricity, water, and drainage must be performed
by a qualified professional.
• Always follow applicable regulations for water, drainage, and
electricity.
• Take care during installation! Wear protective gloves! There must
always be two people!
• Place a drip tray on the floor beneath the dishwasher to prevent
damage from any water leaks.
• Before screwing the dishwasher into place, test the dishwasher by
running the Rinse and hold program. Check that the dishwasher
fills with water and drains. Also check that none of the connections
leak.
WARNING!
Turn off the water supply when installing the dishwasher!
The plug must be disconnected or power to the outlet turned off while
installing the dishwasher!
Setup
• The recess and connection dimensions are included in the separate
installation instructions. Check that all dimensions are correct before
starting the installation. Note that the height of the integrated door
panel can be adjusted to match other fittings.
•
24
5 3/8
2
4
24
33
7/8 - 36
23 5/8*
['']
24'' with the trim kit.
The electrical and water
supplies should enter
through the area
indicated by the shading
on the illustration.
*
• Make sure the area on which the dishwasher is to be installed is
firm. Adjust the adjustable feet so that the dishwasher is level.
Tighten the lock nuts.
• If the dishwasher is built-in, the surrounding furnishings must be
resistant to any condensation from the dishwasher.
• Fit the protective film (packed in the document bag) to the underside
of the countertop. The protective film is to protect the countertop
from moisture.
NOTE!
Framed cabinets require additional finished filler material behind the
face frame for a proper installation. A minimum 3½” (89 mm) finished
return is required on all sides of the opening.
3½”
¾”
3½”
Frameless
cabinetry
Filler
Framed
cabinetry
21
Loading ...
Loading ...
Loading ...