Loading ...
Loading ...
Loading ...
INSTALLATION
The appliance has been designed as exhausting hood (external exhausting)
or ltering one (internal recirculation).
Warning: consult local regulations regarding fumes outlets. Do not connect
the hood to a fume, ventilation or hot air duct. Conrm that room ventilation is
appropriate with the local authorities. Make sure
the maximum air extraction ow rate for the appliances in the room does
not exceed 4 Pa (0.04 mbar).The room must have adequate ventilation if an
extractor hood is used simultaneously with appliances that run on gas or
other fuels. The evacuated air must be extracted through ducts that are
used for evacuating fumes from appliances that run on gas or other fuels.
Regulations regarding air extraction must be complied with.
Use a rigid PVC pipe with a min. Ø l20 mm to evacuate fumes outside.
The above restrictions do not apply to hoods with no fumes outlet to out-
side
(recirculation system with activated charcoal lter).
Install the hood in line with the instructions on the template Install the hood
in line with the instructions on the template provided.
For gas cooking appliances only: the minimum distance to the hood must be
at least 65 cm.
The appliance must be placed in such a way, that the supply plug is acces-
sible.
ELECTRICAL CONNECTION
The appliance is built in class II. so no wire has to be connected with the
earth terminal.
Connect the cord to a socket or double pole switch
The manufacturer shall not be liable for failure to observe all safety regula-
tions in force for the correct and normal operation of electrical parts.
Warning: the hood may stop working during an electrostatic discharge (e. g.
lightning). This involves no risk of damage. Switch o the electricity supply to
the hood and reconnect after one minute.
This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of ex-
perience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user main-
tenance shall not be made by children without supervision.
To avoid the risk of re, clean the metal lter regularly, permanently control
pans containing hot oil and do not ambé food underneath the hood.
Do not use the hood if it shows signs of damage or imperfection. Contact an
ocial distributor or authorised dealer.
Accessible parts may heat up when using cooking appliances.
ATTENTION: should the lamps not work, make sure they are well tightened
MOUNTING OF THE HOOD IN THE LOWER PART OF AN HANGING CUP-
BOARD
Drill 4 holes of 6 mm. diameter at the bottom of the hanging cupboard as
showed in the drawing g. 1.
Fill the hood in the cabinet with 4 screws, which are appropriate to that kind
of cupboard.
The appliance is provided with 2 air outlets, one which is in the upper part
and the other on the back. Both of them can be used according to your re-
quirements.
MOUNTING OF THE HOOD ON THE WALL
Drill 2 holes on the wall, which correspond to the position (B) of the drawing g-1.
Hang the hood on the 2 holes by using the screws and doweis with expanding
plug, which are apropriate for that kind of wall (ex.: concrete, plasterboard,
etc.). Fix denitely the hood through the 2 security holes (Z).
CHANGING FROM EXHAUSTING HOOD TO THE FILTERING ONE
In order to make this change (possible also after the use of the exhausting
system), demand a set of carbon lters to your deales. Active carbon lters
are necessary to depurate the air, that will be released in the room. Filters
are not washable: they cannot be regenerated and have to be replaced at
most every 4 months. The saturation of the activated charcoal depends on
the more or less prolonged use of the hood, on the type of cooking and on the
regularity of cleaning the grease lter.
USE AND MAINTENANCE
Touch panel ECOTC
1- Lighting on and o.
2- Extractor fan speed - button: speed 1, 2 and 3 Press the current speed
again to switch o the extractor fan.
Timer: the extractor fan works for 5 min. at the current speed and another
5 min. at each of the lower speeds until it stops. To cancel the timer: press
the chosen speed button once.
It is advisable to let the appliance work for 15 minutes after the cooking of the
food in order to remove completely the fumes. The eective functioning of
the hood depends on the regularity with which the maintenance operations
are carried out. in particular those of the anti-grease lter.
The anti-grease lter has the function of catching the particles suspended
on the air, so it is subject to get clogged at various intervals, according to the
use of the appliance. In any case at most after two months, it is necessary to
clean the lter by doing the following operations:
• Remove the lter and wash it with a solution of water and neutral liquid
detergent, allowing the dirt to soften. Do not use polish.
• rinse thoroughly with lukewarm water, allow to dry without twisting and
apply it to the grill.
In case the washing instructions of the lter should not be followed, it could
burst into ames.
Clean frequently all the deposits on the fan and on all the other surfaces.
using a cloth moistened by methylated spirits or neutral and not abrasive
uid detersive.
WARNING!!
UNDER CERTAIN CIRCUMSTANCES DOMESTIC APPLIANCES MAY BE DAN-
GEROUS.
• Do not chech lters with hood working.
• Do not toucht the lamps after a prolonged use of the appliance.
• No food must be cooked ambe underneath the hood.
• The use of an unprotected ame is dangerous for the lters and could
cause res.
• Watch constantly the fried food in order to avoid that the cooking oil ares up.
• Before performing any maintenance operation, disconnect the hood from
the mains.
The Manufacturers refuse to accept any responsability for eventual dama-
ges. because of failure to observe the above instructions.
On cooker hoods equipped with tungsten lamps, the lights should only be
used during operation of the motor. They should not be left on permanently
and used as a light source.
Legal information
The manufacturer:
- Declares that this product meets all basic requirements regarding low-
voltage electrical equipment established in Directive 2006/95/EC of 12 De-
cember 2006 and electro-magnetic compatibility established in Directive
2004/108/EC of 15 December 2004.
- Is not responsible for any failure to observe the instructions given in this
manual and current safety regulations for the correct use of the equipment.
- R eserves the right to make any modications to the equipment or this ma-
nual without prior notice.
Contact our ocial distributor should you require technical assistance
or additional information on our products.
EN
Loading ...
Loading ...
Loading ...