Loading ...
Loading ...
Loading ...
7
1. Disconnect power.
2. Remove the hold-down screw and terminal block cover.
A. Terminal block cover
B. External ground conductor screw
C. Center terminal block screw
D. Hold-down screw location
E. Neutral ground wire
F. Hole below terminal block opening
3. Install strain relief.
Electrical Connection
Direct Wire
Power Supply Cord
Style 1: Power supply cord strain relief
■ Remove the screws from a ¾" (19 mm) UL listed strain relief
(UL marking on strain relief). Put the tabs of the two clamp
sections into the hole below the terminal block opening so
that one tab is pointing up and the other is pointing down, and
hold in place. Tighten strain relief screws just enough to hold
the two clamp sections together.
A
B
C
D
A. Strain relief tab pointing up
B. Hole below terminal block opening
C. Clamp section
D. Strain relief tab pointing down
A
B
C
D
E
F
Loading ...
Loading ...
Loading ...