Loading ...
Loading ...
Loading ...
EN
User manual
13
DISCONNECT THE WATER AND POWER
SUPPLIES
Close the water tap after every wash. This will limit wear on
the hydraulic system inside the washing machine and help to
prevent leaks.
Unplug the washing machine when cleaning it and during all
maintenance work.
CLEAN THE WASHING MACHINE
The outer parts and rubber components of the appliance
can be cleaned using a soft cloth soaked in lukewarm soapy
water. Do not use solvents or abrasives.
The washing machine has a “Auto-cleaning” cycle for its
internal parts; it must be run without any load in the drum.
To optimise this cycle, it is possible to use either detergent
(10% of the quantity specied for lightly soiled garments)
or special additives to clean the washing machine. We
recommend running a cleaning cycle every 40 wash cycles.
To start the cycle press buttons and simultaneously
for 5 seconds.
The cycle will start automatically and will run for about 70
minutes. To stop the cycle, press the START/PAUSE button.
A
B
CLEANING THE DETERGENT DISPENSER
DRAWER
To remove the drawer, press lever (1) and pull the drawer
outwards (2) (see gure). Wash it under running water; this
procedureshould be repeated frequently.
2
1
CARE FOR THE DOOR AND DRUM
Always leave the porthole door ajar in order to prevent
unpleasant odours from forming.
CLEAN THE PUMP
The washing machine is tted with a auto-cleaning pump
that does not require any maintenance. Small items (such as
coins or buttons) may sometimes fall into the protective pre-
chamber situated at the base of the pump.
! Make sure the wash cycle has ended and unplug the
appliance.
To access the pre-chamber:
1. Remove the cover panel on the front of the machine by
rst pressing it in the centre then pushing downwards on
both sides to extract it;
2.
1
2
3
Loosen the drainage pump cover by turning it anti-
clockwise: it is normal for some water to leak out;
3. Clean the inside thoroughly;
4. Screw the cover back on;
5. Put the panel back in place, making sure the hooks slot in
place before pushing the panel onto the appliance.
CHECK THE WATER INLET HOSE
Check the water inlet hose at least once a year. If it is cracked
or broken, it must be replaced: during wash cycles, the high
pressure of the water could suddenly split the hose open.
! Never use hoses that have already been used.
CLEANING & MAINTENANCE
Before performing cleaning and maintenance, switch the washing machine o and disconnect it from the mains
power. Do not use ammable liquids to clean the washing machine.
Loading ...
Loading ...
Loading ...