Loading ...
Loading ...
Loading ...
37
Oven
light bulbs
SHOCK OR BURN HAZARD: Before replacing oven
light bulb, disconnect the electrical power to the oven
at the main fuse or circuit breaker panel. Failure to
do so may result in electric shock or burn.
BURN HAZARD: The glass cover and bulb should
be removed when cool. Touching hot glass with bare
hands or a damp cloth can cause burns.
To remove:
1 Turn the glass cover counterclockwise 1/4 turn until
the tabs of the glass cover clear the grooves of the
socket. Wearing latex gloves may offer a better grip.
2 Using gloves or a dry cloth, remove the bulb by
pulling it straight out.
To replace:
1 Use a new 120/130-volt halogen bulb, not to exceed
50 watts. Replace the bulb with the same type of bulb
that was removed. Your model will have one of the
two types shown on the right. To determine the
correct replacement bulb, check the bulb terminals.
Bulbs with 2 straight pin terminals are G6.35 bulbs.
Bulbs with 2 looped terminals are G9 bulbs. (Do not
interchange.) Be sure the replacement bulb is rated
120 volts or 130 volts (NOT 12 volts).
2 Using gloves or a dry cloth, remove the bulb from its
packaging. Do not touch the bulb with bare fingers.
Oil from skin will damage the bulb and shorten
its life.
3 Push the bulb straight into the receptacle all the way.
Then replace the screen. NOTE: The screen must be
replaced or the life of the bulb will be reduced.
4 Place the tabs of the glass cover into the grooves of
the socket. Turn the glass cover clockwise 1/4 turn.
For improved lighting inside the oven, clean the glass
cover frequently using a wet cloth. This should be
done when the oven is completely cool.
5 Reconnect electrical power to the oven.
Care and Cleaning of the Oven
Trivection
™
Wall Oven
G6.35 Bulb
Socket
Tab
Glass cover
Screen
Receptacle
Use gloves
or cloth
Receptacle
BE SURE ELECTRICAL POWER IS OFF AND ALL SURFACES ARE COOL BEFORE CLEANING ANY
PART OF THE OVEN.
How to
remove
packaging
tape
To assure no damage is done to the finish
of the product, the safest way to remove the
adhesive left from packaging tape on new
appliances is an application of a household
liquid dishwashing detergent, mineral oil or
cooking oil.
Apply with a soft cloth and allow to soak.
Wipe dry and then apply an appliance polish
to thoroughly clean and protect the surface.
NOTE: The plastic tape must be removed from all
chrome trim. It cannot be removed if it is baked on.
G9 Bulb
Socket
Tab
Glass cover
Receptacle
(on some models)
WARNING
CAUTION
(on some models)
Screen
Loading ...
Loading ...
Loading ...