BS12350 User Manual

Loading ...

7ASSEMBLY INSTRUCTIONS

ASSEMBLY INSTRUCTIONS

Fitting the heat reflectors

Completely remove all of the plastic film from the reflectors�

The tabbed ends of the heat reflectors face forward to the

front of the barbecue frame� The tabs fit into the slots in the

front end of the barbecue (behind the control fascia)� Key

the tabs of the vaporisers into the lower slots (between the

burners)� Key the tabs of each reflector into the slots� If slots

are partially covered with enamel, work the tabs until the

enamel clears� See Fig 8�

Fitting the burners

Remove the retaining clips from the burners, then fit the

burners - open end first, over the brass stem of the control

valves at the front of the barbecue, allowing the rear

burner lug to locate into the cross-lighting channel and

corresponding hole in the support panel at the rear or the

barbecue� To secure burners fit retaining clips (“R” shape)

into burner lugs� See Fig 9 & 10�

FIG 8

FIG 9

Fitting the vaporisers

Remove the protective plastic film from each vaporiser and

then fit the vaporisers to the barbecue� The tabbed ends

of the vaporisers face forward to the front of the barbecue

frame� The tabs fit into the slots in the front end of the

barbecue (behind the control fascia)� Key the tabs of the

vaporisers into the upper slots� The vaporisers should be

fitted to the same side of the barbecue to which the grill is

to be placed� (They will not work if fitted under the plate)� If

slots are partially covered with enamel, work the tabs until

the enamel clears� See Fig 11 & 12�

FIG 10

FIG 11

Loading ...

User Manual - Page 7