Loading ...
Loading ...
Loading ...
WINDOW REQUIREMENTS
• These instructions are for a standard
double-hung window. You will need
to modify them for other types of
windows.
CAUTION: If the sill support
bolts do not contact the window sill,
or if you have a window without a sill,
you must order accessory kit RAK87 to
properly install this air conditioner. Call
800.626.2002 or visit ge.com.
• All supporting parts must be secured
to firm wood, masonry or metal.
• The electrical outlet must be within
reach of the power cord.
• Follow the dimensions in the table and
illustration for your model.
Models A B
ASD06, ASM08, ASQ10, 14 3/4″ min. 24 3/4″–36″
ASV10
ASM10, ASQ12, ASV12 15 3/8″ min. 26″–39 1/2″
ASM12, ASQ14, ASV14 16 1/4″ min. 26″–39 1/2″
Window Installation Instructions
STORM WINDOW REQUIREMENTS
A storm window frame will not allow the
air conditioner to tilt toward the outside,
and will keep it from draining properly.
To adjust for this, attach a piece of wood
to the sill.
WOOD PIECES –
WIDTH: 2″
LENGTH: Long enough to fit inside the
window frame.
THICKNESS: To determine the thickness,
place a piece of wood on the sill to make
it 1/2″ higher than the top of the storm
window frame or the vinyl frame.
Attach securely with nails or screws
provided by the installer.
2
REMOVE THE FRONT GRILLE
(IF ATTACHED)
Remove shipping tape, if present.
On models with a
raise-up inlet grille,
lift it and remove
the screw behind it
(if present) that holds
the grille in place.
On models with a
slide-out air filter,
remove it and the
screw behind it
(if present) that holds
the grille in place.
Gently but firmly grasp
the lower grille corners,
press in on the case
sides and pull forward
to release.
NOTE: Do not pull the
bottom edge toward
you more than 3″ or
you may damage the tabs of the grille.
Lift the grille up and off the top tabs.
3
11
A
B
C
1/2″ higher
than storm
window
frame
Storm window
frame
Wood
Sill
1/2″ higher
than vinyl frame
(on some windows)
Vinyl frame
1
A
(With accordion panels)
B
Loading ...
Loading ...
Loading ...