2006 PACIFICA User Manual

Loading ...

3. Simultaneously press and hold both the HomeLink

button that you want to train and the hand-held trans-

mitter buttons. Do not release the buttons until step 4

has been completed.

NOTE: Some gate operators and garage door openers

may require you to replace this Programming Step 3 with

procedures noted in the ⬙Gate Operator/Canadian Pro-

gramming⬙ section.

4. The HomeLink indicator light will flash slowly and

then rapidly after HomeLink successfully receives the

frequency signal from the hand-held transmitter and the

EVIC display will show “Channel X Training” (where X

is Channel 1, 2, or 3). Release both buttons after the

indicator light changes from the slow to the rapid flash or

the EVIC display shows “Channel X Trained”.

NOTE: If the EVIC display shows “Did Not Train”

repeat steps 2–4.

5. Press and hold the just trained HomeLink button and

observe the indicator light or the EVIC display. If the

indicator light stays on constantly, programming is

complete and your device should activate when the

HomeLink button is pressed and released. If the EVIC

display shows “Channel X Transmit” (where X is Chan-

nel 1, 2, or 3), programming is complete and your device

should activate when the HomeLink button is pressed

and released.

NOTE: To program the remaining two HomeLink but-

tons, begin with ⬙Programming⬙ step two. Do not repeat

step one.

If the indicator light blinks rapidly for two seconds and

then turns to a constant light continue with ⴖProgram-

mingⴖ steps 6-8 to complete the programming of a rolling

code equipped device (most commonly a garage door

opener).

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 145

Loading ...

User Manual - Page 145