Loading ...
Loading ...
Loading ...
’08 Corolla_U (L/O 0706)
280
2008 COROLLA from Aug. ’07 Prod. (OM12B28U)
The following illustrations show how to
gain access to the bulbs. When replacing
a bulb, make sure the ignition switch and
light switch are off. Use bulbs with the
wattage ratings given in the table.
Vehicles with rear spoiler—The high
mounted stoplight consists of a number of
LEDs. If any of the LEDs burn out, take
your vehicle to your Toyota dealer to have
the light replaced.
CAUTION
To prevent burning yourself, do not
replace the light bulbs while they
are hot.
Halogen bulbs have pressurized gas
inside and require special handling.
They can burst or shatter if
scratched or dropped. Hold a bulb
only by its plastic or metal case.
Do not touch the glass part of a
bulb with bare hands.
NOTICE
Only use a bulb of the listed type.
The inside of the lens of exterior lights
such as headlights may temporarily fog up
when the lens becomes wet in the rain or
in a car wash. This is not a problem
because the fogging is caused by the
temperature difference between the outside
and inside of the lens, just like the
windshield fogs up in the rain. However, if
there is a large drop of water on the
inside of the lens, or if there is water
pooled inside the light, contact your
Toyota dealer.
Light bulbs
Bulb
No.
W Type
Headlights
(high beam)
9005 65 A
Headlights
(low beam)
9006 55 B
Parking/front side
marker/front turn
signal lights
3157A 27/8 C
Front fog lights 9006 55 B
Rear side marker
and stop/tail lights
3157 27/8 D
Rear turn signal
lights
3157A 27/8 C
Back−up lights 921 18 D
High mounted
stoplight
921 18 D
License plate lights — 5 D
Interior light — 8 E
Replacing light bulbs—
Loading ...
Loading ...
Loading ...