Loading ...
Loading ...
Loading ...
Assembly
Mount to the wall
1. Determine the desired location of the wall fan (must be 1.8m from the oor) and
ensure the wall is structurely sound to cope with the load of the fan.
2. Hold the wall bracket (13) in position, and mark the screw holes with a pencil.
Ensure everything is marked horizontally and aligned before drilling.
3. Drill the holes where the pencil marks are to suit the 4 x xing anchors (12).
4. Mount the wall bracket (13) on the wall with the 4 x xing anchors (12)
Assemble the motor to the xing bar
1. Attached the fan motor (8) to the xing bar (11) by aligning the motor xing hole
(9) with the xing bar hole (10) and use the long bolt and washer supplied to
secure.
2. Place the bottom of the xing bar (11) into the wall bracket (13) and use the
bracket xing pole screws (14) to tighten and secure to the bracket.
Attach the rear grille
1. Align the rear grille (5) to motor shaft (6) on the fan motor (8) and ensure the
hole for the safety screw is at the bottom. The 4 screw holes on the front of the
fan motor (8) should line up. Firmly tighten all four rear grille screws (4).
Attach the fan blade
1. Once the rear grille (5) is attached to the fan motor (8), turn the motor shaft
(6) so the at area is at the top. Slide the fan blade (3) all the way onto the
motor shaft (6) and rmly tighten the grub screw (2) by rotating in a clockwise
direction.
Attach the front grille
1. Once the fan blade is xed, align the top locking clip on the front grille (1) so it
xes to the that of the rear grille (5). Lock the side and bottom clips in place.
2. Secure the front & rear grille, by inserting and xing the safety screw (15) and nut.
TIP: the logo should be horizontal.
Remote
Insert 1 x A23 12V batteries (not included) into the remote.
11. Fixing bar
7
Loading ...
Loading ...
Loading ...