Loading ...
Loading ...
Loading ...
2. Remove two screws attaching access paneH and bwer
panei to dishwasher using a 1/4" hex socket, nut driver
or PMHips screwdriver.
3. Remove paneHs and set paneHs aside on a protective
surface.
4. Check that grounding chip is attached to the bwer
panel,
lower
panel
clip
water inlet valve
5. AppiyTefion :" tape or pipe
joint compound to 90 °eibow
fitting and connect fitting to
water iniet vaive.
6. Tighten elbow until snug, and
be sure that it faces to the
rear.
7. Remove terminal box cover. Puii appliance wires
through hoie in terminai box. Do not untie the knot in
the wires.
- if you are direct wiring: install a U,h-listed/CSAo
certified damp connector to the terminai box, if using
conduit, use a U,L,olisted/CSAocertified conduit
connector,
- if you are installing a power suppiy cord kit, do so
now, following kit instructions,
dishwasher
wires --...
\
cable clamp connector
HeJpfuJTip: Put cardboard under dishwasher until it is
instaiied in cabinet opening.The cardboard wiii heip
protect floor covering during instaiiation.
Measure height of cabinet opening
from underside of countertop to
floor where dishwasher will be
instaiied (you need the iowest
point). Check chart for that height
opening. Put wheeis in the required
position.
wheel
Number of
Minimum Wheel
turns on
cutout height position front leg
34" (86.4 cm) 1 10
34-1/4" (87 cm) 2 5
34-I/2" (87.6 cm) 3 0
9,
Turn both front ieveier iegs to the same
height.
If the minimum cutout height is less than
34" (86.4 cm), the rear wheels can be
removed for additional clearance.This will
aiiow the dishwasher to fit into a 33-7/8"
(86 cm) high cutout, but the dishwasher
wiii be more difficult to move into
position, if the wheeis are removed, front leg
protect the floor when moving the dishwasher.
If you have built-up
floors
1. Measure height of opening
from underside of
countertop to buiit_up
fioon If the height is at
ieast 33-3/4" (85.7 cm), the
dishwasher will fit into the
opening without
modification to the
countertop or flooring.
2. Put wheeis in position 1
j countertop
rr
33-3/4"
(65,7 cm)
rain.
3,
and turn the front leveler iegs up all the way.
Add shims as needed in the area shown to bring
dishwasher up to proper height.
NOTE: Shims must be secureiy attached to floor to
prevent their movement when the dishwasher is
operated.
2"
(5.1 cm)
2-3/4" 6" 2-3/4"
(7.0cm) (15,2cm) (Z0 cm)
Install custom door panel kit (on some modeis)
if instaiiing a custom door panei kit, instaii in now foiiowing
instructions included with kit,
10
Loading ...
Loading ...
Loading ...