Loading ...
Loading ...
Loading ...
installation instructions ........
To use toggle bolts:
Mounting
Plate
Spacingfor TogglesMore
-_,_ ThanWaltThickness
ToggleWings
BoltFnd
[_] Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall
to mount the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed flush
against the wall and that the plate is properiy
centered under the cabinet,
CA17rION: Be careful to avoid pinching fingers
between the back of the mounting plate and the wall,
Tighten all bolts_ Pull the plate away from the wall
to help tighten the bolts.
[_ USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enough for the power' cord to fit through
" Read the instructions on the I'OP CABINE_[ '
TEMPLATE,
='Iape it underneath the top cabinet
o Drill the holes, following the instructions on the
TOP CABINET 'IEMPLikIE,
GAIYEION: Wear safety goggles when drilling holes
in the cabinet bottom,
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST
[_ Remove and save screws that hold the blowe_
plate and blower motor to the microwave hood
and remove the blower plate,
BlowerPlate
Backof
Microwave
Hood
BlowerMotor
Screw
[2_ Carefully pull out tile blower unit, The wires
will extend far enough to allow you to adjust the
blower unit,,
BEFORE: Fan Blade
Openings Facing ....
EndA"_
!
[_ Rotate blower unit counterclockwise 180°,,
BeforeRotation AfterRotation
/ /
Backof MicrowaveHood BackofMicrowave Hood
16
Loading ...
Loading ...
Loading ...