Loading ...
Loading ...
Loading ...
11DOOR TO CABINET ASSEMBLY
DOOR TO CABINET ASSEMBLY
1. Select correct handed hinge.
2. Place top hinge on top of cabinet.
3. Drive rear screw in half way using battery drill with
8mm socket.
NOTE: Tapping plate is not threaded. Screw is a thread
forming screw.
4. Fit door to bottom hinge pin on cabinet.
5. Lift top hinge and insert top hinge pin into door
endcap.
6. Using 8mm socket finger tighten screw.
7. Drive other 2 top hinge screws into place using
battery drill with 8mm socket leaving finger tight to
allow alignment of door.
8. Align door.
• Align handle side of door at top to be flush
with cabinet.
• Set door gasket gap (hinge side) to 9mm.
9mm
9. Tighten all 3 top hinge screws (recommended
torque 8Nm).
10. Select correct handed and coloured hinge cover.
11. Open door and fit top hinge cover.
12. Close door and fit top hinge cover screw.
Loading ...
Loading ...
Loading ...